Here are just a few reasons why you may need a provisional CEMS from the "CEMS Experts":

Temporary replacement for an existing CEMS

If your CEMS breaks down and can’t be repaired in a timely fashion, we can supply a provisional system to keep you in compliance and help avoid costly fines.

CEMS Data Quality Verification

Do you have some question about the reliability of your existing CEMS data?  Perhaps there is a random glitch that sends your hourly emissions over your permit limit that you can’t seem to pinpoint.  At a fraction of the cost for what a RATA Emissions Test company would charge to mobilize and collect data, our rental CEMS could be your answer.

New CEMS Installation Delays

You ordered a CEMS already for your new plant or process and the delivery is delayed for whatever reason.  The deadline on your permit is fast approaching (or past) and you need emissions data NOW!  Give us a call and we can have a temporary system delivered, installed and certified within one week!

Process Emissions Modeling or Assessment

If a CEMS is not required on your process but you want to collect emissions data over time to model your pollutants, diluents, carbon footprint or make improvements in your combustion efficiency, use our rental CEMS to do this very cost-effectively.  We can also help you set up our CEMS and associated sensors and process monitors to provide a complete data set for Predictive Emissions Monitoring (PEMS) certification.

SCR Ammonia Slip Verification

Rent our "Hot/Wet" NH3 ammonia CEMS to verify that your Selective Catalytic Reduction (SCR) system is working properly.  This system give you accurate (+/- 0.1ppm) NH3 slip data in real-time, so you don’t have to wait hours (or days) for wet chemistry results from an on-site testing service.  Our customers have saved hundreds of thousands of dollars by adjusting various process parameters and configurations on their SCR profiles to avoid unnecessary replacement of their expensive SCR catalyst beds!

New CEMS Pre-purchase Engineering Modeling

Before you can even provide a specification to a CEMS vendor what your process emission requirements will be, you need to get accurate data over various process conditions to determine the ranges for your new analyzers.  For less than the cost of a new hand-held monitor, we can provide you with a complete, turn-key rental CEM solution that uses state-of-the-art, industry standard instrumentation with proven accuracy.   

Cement                                       Waste Incinerators

Land Fill Emissions                     Pulp and Paper

Biomass                                      Semiconductor

Steel mills                                   Glass manufacturing

Boilers                                         Gas Turbines

Reciprocating Engines                 Coal and Coke fired

Oil Refinery Processes                 SCR NH3 Slip Monitoring

Plastics Manufacturing                 Off-shore Drilling and Marine